Problems

[Cireous]

Im ready to blow this dam thing up. I got a 2000 Busa. I changed out the ECU 02’, wire harness 06’, start switch 06’. Everything comes on lights, fuel pump. No FI codes. I hit the start button and nothing. No crank. I’ve checked all my connectors and switches. I’ve checked the starter solenoid. Everything is good. Anyone got any clue???

 

[GIXERHP]

What fuel pump and tank are you using ?

 

[David Offor]

30amp fuse under the riders seat, seems like a common one, to give no starting.

 

[Cireous]

What fuel pump and tank are you using ?

2000 tank and pump. Pump primes like it’s suppose to

 

[Cireous]

30amp fuse under the riders seat, seems like a common one, to give no starting.

If it was blown, I wouldn’t get no dash or fuel pump, would?

 

[busa2001]

Do you hear the starter relay click when you hit the start button? check at the relay you should have a ground signal at the relay coil and when you hit the starter button you should have 12v on the other side of the relay coil. if you don't have the 12v check the engine kill switch, you should have 12v at the switch, also check the side stand switch and turn signal/ side stand relay. It's also best to make sure bike is in neutral.

 

[Cireous]

Well I may have it narrowed down. I’m going to be checking the clutch lever switch. All of the above you guys mentioned is good to go. Wish me luck.

 

[jermzfree]

It sounds like you replaced the right handle bar assembly (starter/kill switch). Not sure if the left handlebar assembly (turn signal/brights) is necessary, but the wiring is a little different between 00 and 06

 

[Cireous]

Yea it was both switches. I’ve replaced both and everything is fine now