hayabusa317
Registered
For anyone needing to install one of these here it is.
Take apart the factory kill switch housing that is already on the bike, near the front brake lever. Be carefull not to put too much stress on the soldered connections on the bottom of the switch when taking it apart. If not you will need to solder back like I had too.
The tricky part of taking this switch off is taking the throttle cables off the bars, you will figure it out, on cable has the ability to be slide off and on after the other is attached. Take your time be patient especially when putting back together.
Ok there are two wires on this model. 1 is Orange and has a Black stripe, the other is Orange and has a White stripe. Use the Orange wire with the Black stripe to connect your lanyanrd kill switch.
I did solder, not much experience. So I did get my ass kicked real good until I got it.
Take apart the factory kill switch housing that is already on the bike, near the front brake lever. Be carefull not to put too much stress on the soldered connections on the bottom of the switch when taking it apart. If not you will need to solder back like I had too.
The tricky part of taking this switch off is taking the throttle cables off the bars, you will figure it out, on cable has the ability to be slide off and on after the other is attached. Take your time be patient especially when putting back together.
Ok there are two wires on this model. 1 is Orange and has a Black stripe, the other is Orange and has a White stripe. Use the Orange wire with the Black stripe to connect your lanyanrd kill switch.
I did solder, not much experience. So I did get my ass kicked real good until I got it.
