Hi, all;
I am once again on a quest for an undertail that retains the stock taillight (out 250 for a motorhead that was too thin to mount). I came across one that I'm thinking of picking up, but I need to cut my stock undertail. I am considering plastic welding it to the stock undertail (as they're both ABS), but I wanted to see if any of you guys have any recommendations as far as plastic welders. I was looking at a Urethane Supply Company 5500HT airless welder, but I'm not sure if that's the right type I need for this.
TIA,
Hajii
I am once again on a quest for an undertail that retains the stock taillight (out 250 for a motorhead that was too thin to mount). I came across one that I'm thinking of picking up, but I need to cut my stock undertail. I am considering plastic welding it to the stock undertail (as they're both ABS), but I wanted to see if any of you guys have any recommendations as far as plastic welders. I was looking at a Urethane Supply Company 5500HT airless welder, but I'm not sure if that's the right type I need for this.
TIA,
Hajii