PING: Ninja Killer & bigmac0331

[omslaw]

Sorry for the crappy shoe-phone pics, but I just got it done...

 

[omslaw]

This should work for ya:

 

[omslaw]

Rusty - holla at me tomorrow; I have the chain tool and socket in my truck. Do you have a dremel or angle grinder to grind down the rivet head? You'll definitely want to do that before pressing them out...

 

[NINJA KILLER]

SWEET !!!! Thanks BRO ! S-R Racing (John) told me he would bring one but Rusty will need it to remove Robyn's swingarm so we can swap them out. Thanks !!!!!!

You Da Man !!!

 

[NINJA KILLER]

Where is this Rivet Head located at ?

 

[omslaw]

On the chain master link; the two rivets holding it on. You'll want to grind those flush with the link; it will put less stress on the chain tool when pushing the rest of the rivet thru.

 

[NINJA KILLER]

Thanks Bro!!!

 

[omslaw]

Bob - check this thread out: https://www.hayabusa.org/forums/?act=ST;f=24;t=79696

Ted does a nice write-up on how to change the chain. He has the same chain tool that I have. Also - keep reading, cuz the first time he pressed the rivets on, he used the wrong anvil...

 

[semi]

very nice piece

 

[bigmac0331]

OMAR IS THE MAN!!!!!!!!!!! Thank you so much!!!!!!

 

[NoFearSpear]

Bob - check this thread out:  https://www.hayabusa.org/forums/?act=ST;f=24;t=79696

Ted does a nice write-up on how to change the chain.  He has the same chain tool that I have.  Also - keep reading, cuz the first time he pressed the rivets on, he used the wrong anvil...

and use the spacer that comes with the new master link.

 

[omslaw]

Bob - check this thread out: https://www.hayabusa.org/forums/?act=ST;f=24;t=79696

Ted does a nice write-up on how to change the chain. He has the same chain tool that I have. Also - keep reading, cuz the first time he pressed the rivets on, he used the wrong anvil...

and use the spacer that comes with the new master link.

I keep a couple in with the chain tool

 

[omslaw]

Rusty - holla at me tomorrow; I have the chain tool and socket in my truck. Do you have a dremel or angle grinder to grind down the rivet head? You'll definitely want to do that before pressing them out...

Just tossed the calipers in, too. Some knowledge-transfer tomorrow and you'll be set

 

[NINJA KILLER]

Thanks for the Help BRO !!!

 

[BigBSBusa]

Looks like some good stuff happening over there. Wish I was there to help.