Open question to Erik Gendron of Mototeck

[Guest]

Hi Erik,
Am puzzled as to why u did not design colored face dials for the fuel gauge and temp gauge of the Hayabusa as well ... don't u think it'll look even more beautiful?

 

[OB_bimmerbusa]

he is working on it. problem with riveted stops needles. i agree all 4 would look
great.

 

[OB_BullDog]

Just curious, those who have installed Mototeck speedo guage... Is the stopper pin above zero? Which leaves the needle at about 5kph when at rest? My speedo reading is accurate, just that the stopper pin is offset...

Just me? Or everyones? Thanks....

P.S.: AWESOME PRODUCT! Everyone should buy it!!

[This message has been edited by BullDog (edited 08 April 2000).]

 

[OB_SlowHand]

Bulldog, no, mine rests on the pin, just like stock. You need to hold the needle gently against the stop when removing and installing the needles.

 

[OB_BullDog]

I edited my last msg as I was half asleep when I wrote it.. a few mistakes..

The stopper pin should be a little to the right of the "0" mark... like my Tach.. by on my speedo, the stopper pin hole in directly above the 0kph mark, which means the needle can only come back to about 5 kph.

Wish I had a digital camera to show you.

Getting ALOT of comments on the face guages...

Eric have you contacted any dealers in my area yet?

I have Kawa friends chomping at the bit for these guages!! ZX6,9 & 12!