Lucid
Registered
'09.
I installed a Brock's Street Meg and a PCV. I had the Brock's installed for about a week before the PCV got here. Brock's instructions say you should just run the o2 sensor plugged in but not installed in the pipe if you don't have the PC with the o2 eliminator, so I did that. With this setup, I was still throwing the o2 sensor FI light. I just ignored it because I knew I was about to eliminate the o2 sensor with the PCV.
I installed the PCV today with the o2 eliminator. I'm still getting the c44 code (o2 sensor). After riding it around a bit to see if the code would go away, I unplugged the battery for about 10 minutes to reset the ECU and I am still getting this code. Anyone have any ideas on how to fix this? Maybe it will just go off after riding it more?
I installed a Brock's Street Meg and a PCV. I had the Brock's installed for about a week before the PCV got here. Brock's instructions say you should just run the o2 sensor plugged in but not installed in the pipe if you don't have the PC with the o2 eliminator, so I did that. With this setup, I was still throwing the o2 sensor FI light. I just ignored it because I knew I was about to eliminate the o2 sensor with the PCV.
I installed the PCV today with the o2 eliminator. I'm still getting the c44 code (o2 sensor). After riding it around a bit to see if the code would go away, I unplugged the battery for about 10 minutes to reset the ECU and I am still getting this code. Anyone have any ideas on how to fix this? Maybe it will just go off after riding it more?