Nitrous fuel adding

[blueghost]

I`m anting to add a 30-40hp shot how do you add the needed fuel to the pcIII usb, and how do you know how much to add using the high button on the PCIIIusb.

 

[busa crazy]

you need to put the bike in neutral,and pull the clutch in and put a tie strap around the clutch so it holds the clutch in. make the tie strap to where you can take it off with little effort. then hold all 3 buttons down on the pc  and dont let them go,turn the bike on and let the instruments do their thing, then start the bike,after the bike starts, then let off the buttons. go to the high side button and tap it until the bars go all the way to the top.let the bike run and watch the pc until the bar goes from the top to the bottom,that means your pc is set!! turn the bike off!!! to be safe it's always smart to run the pc all the way up on the high side when spraying. i would drether have too much fuel than not enough!!!

 

[blueghost]

Thanks

 

[Superbusa]

you need to get a new custom map for you pc3. why go thru the expense of putting spray on your bike then half a$$ the set-up. if you add too much fuel then your helping yourself.

 

[busa crazy]

YOU WILL NEED TO GET A MAP!!! BUT THAT WILL GET YOU BY, UNTIL YOU CAN GET ONE!!!