BigRod1300
Registered
Weekend one: beak-down the bike, remove fact exhaust and Pair valve, instal Brocks block-off plates, install BMC filter with small air box mod, and install PCIII.
new mods
- Thread starter BigRod1300
- Start date
BigRod1300
Registered
Brocks plates may be more $$$ but I LIKE THE o-RING.
BigRod1300
Registered
THE pROGRAMMER LOOKS LIKE IT BELONG THERE.
BigRod1300
Registered
Weekend two: pipes arrive after four week wait.
BigRod1300
Registered
getting late but the pipes are on.
BigRod1300
Registered
another pic
BigRod1300
Registered
finally back together.
BigRod1300
Registered
pic 2
BigRod1300
Registered
pic 3:
The power gain is unreal. the sound is bad ass with out being too loud!
The power gain is unreal. the sound is bad ass with out being too loud!
Nice job, you got the new version of the HMF High mounts. Mine has 4 individual header tubes, (2) 2-1 collectors, then x-pipe, then s-pipes.
Your bike looks great.
Don
Your bike looks great.
Don
mike04busa
Registered
Bike looks good I like the highmount.
Pipefighter248
Donating Member
it actually does look like it...lol could be a bad angle... i got a friend that has his MOUNTED ALL THE WAY UP TO THE PLASTICS on his.. looks nice.. they are carbon fiber ass well so they dont get TOO TOO hot(Shibumi @ Sep. 03 2007,20:49) Is that left can a fraction higher than the right?
Just kidding!!
I was there when USN was lining his up, just about drove him nucking futs!!
Looking good!
