new billet fuel rail install

Iceman_2770

Registered
so i'm setting up the fuel system for my new turbo setup and i have gone with a new billet fuel rail, bosch pump and 1:1 rising pressure regulator.

it has three ports for the fuel to come in. one at each end and one in the middle.
what is the best way to set it up? fuel in from one side or fuel in from the center?
can i take the fuel pressure regulator return line to the pump inlet or is it best to go back to the tank?

thanks
 
If it's a 3 port usually, usually the sides are the inlets, and the bottom port is the return.

Set up is as follows:

Tank to inlet of fuel pump.

Outlet of fuel pump to inlet of fuel rail.

Outlet of fuel rail to the inlet if the FPR.

Outlet of FPR to what use to be the factory feed fitting.
 
Back
Top