Need help with PCIII

[Htown Busa]

I am installing a PCIII on my 2008. It is installed. I have crimped the pink/black wire on the TPS and grounded the PCIII but it is not getting any power. I hooked up the supplied 9 volt adapter. Located the O2 sensor. I go to start the bike up but it won't turn over.

I disconnect everything and the bike starts up. What could I be doing wrong?

 

[Professor]

Makes sure one of the pins didn't get pushed down on the harness connectors.

 

[TruWrecks]

The PC3 should get power when the fuel pump primes. Then it will loose power. If you're not getting the fuel pump prime the battery connection would be suspect. If the fuel pump does prime, but you still get no power to the PC3, I would check to make sure all of the injector plugs and the tapped TPS wire are clean and firmly seated. I would make sure your ground wire also has a good connection.

 

[Htown Busa]

Thanks, I will try again tomorrow.

 

[Johnnycheese]

never crimp solder only

 

[dadofthree]

Good luck my brother