Need Help with Gear Position Sensor green 1 K2

[ImmortalPMCWG]

Вот обновлённый вариант текста для форума, с добавлением про две маленькие клеммы:

---

Subject: Need full pinout and resistance values for Gear Position Sensor (37730-24F00) – including 2 small terminals


Hi everyone,


I’m working on a faulty Gear Position Sensor for a Suzuki GSX1300R Hayabusa K2 (Part number: 37730-24F00). One of the terminals appears to be damaged, and I’m trying to repair it by checking and replacing the correct resistor.


I found the resistance values for the 6 gears and neutral — they were super helpful, thank you!


6th gear – 15K ohm <br>5th gear – 6.8K ohm <br>4th gear – 2.75K ohm <br>3rd gear – 1.5K ohm <br>2nd gear – 835 ohm <br>1st gear – 588 ohm <br>Neutral – open (infinite resistance)<br>

However, this sensor has 7 large terminals and 2 small ones (as seen in the attached photo), and I couldn’t find any reliable info about what the two small terminals are for, or what resistance/voltage values they should read in each gear or in neutral.


If anyone has a full pinout diagram or knows the function and values of these 2 small terminals — that would be a huge help.


Thanks in advance!
Greetings from Russia

---

Если хочешь, я могу перевести и на французский или немецкий, если вдруг попадёшь на профильный форум не на английском.

 

[sixpack577]

@GIXERHP ?

 

[smithabusa]

small terminal between 1st and second is neutral, the blue wire is connected to it and gets grounded when in neutral position, and lights the lamp on dash. center is ground

 

[ImmortalPMCWG]

small terminal between 1st and second is neutral, the blue wire is connected to it and gets grounded when in neutral position, and lights the lamp on dash. center is ground

Thank you for your reply. Could you please tell me what the second small pin is for — the one that is not connected to the blue wire? I tried using a sensor from another Hayabusa that only had one small pin, and it didn't work.

 

[smithabusa]

Thank you for your reply. Could you please tell me what the second small pin is for — the one that is not connected to the blue wire? I tried using a sensor from another Hayabusa that only had one small pin, and it didn't work.

nothing