About the Rolls Royce Merlin engine used in the P-51 Mustang:
The Merlin consumed an enormous volume of air at full power (equivalent to the volume of a single-decker bus per minute), and with the exhaust gases exiting at 1,300 mph (2,100 km/h) it was realised that useful thrust could be gained simply by angling the gases backwards instead of venting sideways.
During tests, 70 pounds-force (310 N; 32 kgf) thrust at 300 miles per hour (480 km/h), or roughly 70 horsepower (52 kW) was obtained which increased the level maximum speed of the Spitfire by 10 mph (16 km/h) to 360 mph (580 km/h).[22] The first versions of the ejector exhausts featured round outlets, while subsequent versions of the system used "fishtail" style outlets which marginally increased thrust and reduced exhaust glare for night flying.
In September 1937 the Spitfire prototype, K5054, was fitted with ejector type exhausts. Later marks of the Spitfire used a variation of this exhaust system fitted with forward-facing intake ducts to distribute hot air out to the wing-mounted guns to prevent freezing and stoppages at high altitudes, replacing an earlier system that used heated air from the engine coolant radiator. The latter system had become ineffective due to improvements to the Merlin itself which allowed higher operating altitudes where air temperatures are lower.[23] Ejector exhausts were also fitted to other Merlin-powered aircraft.
The Merlin consumed an enormous volume of air at full power (equivalent to the volume of a single-decker bus per minute), and with the exhaust gases exiting at 1,300 mph (2,100 km/h) it was realised that useful thrust could be gained simply by angling the gases backwards instead of venting sideways.
During tests, 70 pounds-force (310 N; 32 kgf) thrust at 300 miles per hour (480 km/h), or roughly 70 horsepower (52 kW) was obtained which increased the level maximum speed of the Spitfire by 10 mph (16 km/h) to 360 mph (580 km/h).[22] The first versions of the ejector exhausts featured round outlets, while subsequent versions of the system used "fishtail" style outlets which marginally increased thrust and reduced exhaust glare for night flying.
In September 1937 the Spitfire prototype, K5054, was fitted with ejector type exhausts. Later marks of the Spitfire used a variation of this exhaust system fitted with forward-facing intake ducts to distribute hot air out to the wing-mounted guns to prevent freezing and stoppages at high altitudes, replacing an earlier system that used heated air from the engine coolant radiator. The latter system had become ineffective due to improvements to the Merlin itself which allowed higher operating altitudes where air temperatures are lower.[23] Ejector exhausts were also fitted to other Merlin-powered aircraft.
