I took the fairings off before I took the bike to inspection, and I have this longish somewhat elongated U shaped piece of metal that was somewhere. It has 5 holes, 3 of them in the center that are just holes and 2 of them on the ends that the fairing bolts will screw into. I'm looking through the service manual and can't find this piece in the chassis section. Any experts out there care to give me a clue?
Leftover metal piece after removing fairings
- Thread starter ThatGuyD
- Start date
It’s a fairing brace underneath holding the two halves together.
See Red, that didn’t take nearly eight minutes.
See Red, that didn’t take nearly eight minutes.
RedBull
Registered
It’s a fairing brace underneath
holding the two halves together .
See Red,
that didn’t take
nearly eight minutes .
I knew you were retired...only us retired people have time to either research this or look at your research...
RedBull
Registered
Once my wife gets retired too ~ we plan to enjoy Canada by train *
We have been on the train both to & from Vancouver out of Everett Washington *
Similar threads
