Latest on rear flushmount signals?

[OB_Dirty Pete]

Jack the FSMD lamps are flush and fit tight all the way around. $40 from FSMD. More than adaquate brightness and visibility.

 

[OB_What A Rush]

Check this site
http://www.graphicartmotodesign.com/

 

[OB_GrumpyCop]

Here's a photo of how I did it. I used some Lockhart Phillips signals. Was the best way I could do it with minimal damage to the bike. Provides enough visiblity to be seen when activated but are tucked away and nearly invisible from car level when not in use. As you can't really tell from the pic I have the FMSD tail and hugger in there.

http://albums.photopoint.com/j/ViewPhoto?u=218180&a=1614242&p=15559250

 

[OB_THE MOTORHEAD]

USE the airtech.led type mini signals they look great and last.

 

[Guest]

Did you guys use a hole saw or drill a smaller hole and file/sand to size? Is there a problem with lens wanting to rotate or did you seal/stick them down with silicone? As always, Thanks for help! Jack

 

[OB_cbxchris]

You can also put your turn signals in your tail light with the proper kit....

 

[OB_GrumpyCop]

I treid to use an integrator kit in the rear, but during the daylight you couldn't tell which flasher was on. As far as mounting the new lights I just bored out some large holes in the underfender and siliconed the signals on.

 

[Guest]

I'm sure this has been discussed before, but What's everyone doing for rear signal replacement? I got lots of stuff using the search, just not about signals. I know that LP offers some but look to large. I saw pictures of Dirty Petes bike and his look great. Think they are FSMD units. Does anyone else make a light that flush mounts? Do the FSMD lights follow the curvature of the tail section, or do they stick out on the ends? Any help? Jack.

 

[OB_cbxchris]

Friend in Canada put signals in tail light and used one of those license tag frames with turn signals on sides...looks OK.