Is this normal with all busa's

1999hayabusa

Registered
Hi Guys,
This is my first busa, its a 99 unristricted version. I have installed a new wiring harness and everything is working fine with NO error codes in the cluster. I am just confused about the temp gauge.. When the ignition key is switched on, the gauges do a self check and comes to their normal position but after few seconds the temp needle goes high to the red. This happens when the red kill switch is in off position and when the kill switch is on, the temp gauge comes to its normal position and i can hear the fuel pump sound.

Is this normal with all busa's ?? Plz suggest...
 
If it's going to the red while the bike is still off then you are good to go. My bike also does the same thing until you start it.
 
Back
Top