SmokeKingOfCali99Hayabusa
Registered
Sometimes this comes off my clutch switch assembly. Is there a easy fix/something simple on how to stop it from coming off?.
How do exactly do this?. And what tool would I need?.crimp the connectors a little tighter
What kind of super clue? And where could I get the fittings locally?touch of super glue or replace the fittings on the wire to tighter ones.
Sometimes this comes off my clutch switch assembly. Is there a easy fix/something simple on how to stop it from coming off?.
As already said. Tighten up the female side of the connection. A light squeeze with some pliers should take care of it. I would NOT suggest using any glue.
What kind of super clue? And where could I get the fittings locally?
Lol I’m replacing all that . The bike was like thy already. My uncle had it sitting ....and while you are at it - clean that bike a little. That looks nasty and hurts my eyes!
Thanks broAny superglue heck walmart, office depot, gas station, heck anyplace. As for the fittings, any electronics parts store, or auto parts store will sell the fittings as well as a crimping tool.
Ohhh okay appreciate it bro. I had just bought some todayFrom the looks of the rust I can see there’s probably some inside the connector that‘s maybe preventing a good ’catch’ inside.
Thanks big homieAny superglue heck walmart, office depot, gas station, heck anyplace. As for the fittings, any electronics parts store, or auto parts store will sell the fittings as well as a crimping tool.
Oh yeah definitely that sounds like a planDo a thread on your gen1 to gen 2 conversion. I bet a lot of people love to watch and offer advice if you need,