Installing Scorpio alarm

[PsychoZ]

what is the easiest way to access the tails wires so I can plug in, I am using the wire harness made for the Suzuki so I need to get to the connectors.

thanks

 

[ralnsplder]

you have to pull the entire tail section away from the frame. pull the clips off of the undertail section and remove the 4 allenhead bolts on the side of the rear tail section. you will also haveto remove the black screws and the 4 bolts holding on the grab rail. last thing you need to disconnect will be the lock cable for the rear seat. once that is all done, you can either remove the tail section of just slide it back. You will then see the connector for the tail lights. it is right behing the inner fairing. Hope this helps

 

[Sane_man]

What he said.

After you have done it once, it only takes about 3-4 minutes to remove.

 

[BigBSBusa]

Check out Icemann's thread for: <a href="https://www.hayabusa.org/cgi-bin/busa/ikonboard.cgi?act=ST&f=11&t=12527&st=">Scorpio Install<a>

 

[PsychoZ]

thanks for the responses, I will be doing it Icemann's way