how to install a hotbodies undertail?

[blk out]

it this easy or difficult to do?

 

[RYC1966]

You have to cut most of the stock out plastic...being carefull to leave necessary areas.
It is not hard, usea dremel or cut off wheel to remmove plastic. File the rough edge for looks, just keep trying to fit the undertail in...then remove areas that are in the way...repeat.
Once the part fits and is fastened in...attach the wires. Use a circut tester to see what each lead is or look up the service manual. Most of the time is cutting out the stock part, take your time.


Ryan

 

[BigBSBusa]

Welcome to the board! Gen1 or Gen2 Busa? From what I've heard/read not too tough, but can be kind of tricky for fit.

 

[ks-waterbug]

Welcome to the oRg should get your answers here....