I finally decided to do the install today. Ordered all options. Unfortunately, it looks like I am missing the perimeter sensor. I received instructions for the SN-4 Perimeter sensor, but the invoice says SN-5 perimeter sensor. I'll call them on Monday.
Now to my question. The factory harness has two male connectors for the rear turn signals but I didn't find the same size connectors along the lines. Should I just splice the signal wires? I am mounting my control module along the left side of the tail section. For anyone who has mounted theirs like Icemann, where did you route the antenna.
Now to my question. The factory harness has two male connectors for the rear turn signals but I didn't find the same size connectors along the lines. Should I just splice the signal wires? I am mounting my control module along the left side of the tail section. For anyone who has mounted theirs like Icemann, where did you route the antenna.