help please c23 fault fi light

streetfighter

Registered
i have just recently rebuilt my busa and it wont start every now and then it will start run for a second high rev up and stop
c23 is the fault that is coming up
the bike is a 2000 model
tre fitted
powercommander
boz full system
k&n filter


i put the little block off plates onn the engine
i blocked off the vacum valve on the air box
i blocked off the pipe that leads to the setup on the front of the engine that i took off when i replaced them with the block off plates


when i turn the ignition on at first it comes up fi light on display and the fi light flashes

i have no side stand switch on anymore


it turns over real good sounds like it just needs somthing easy to fix this


if you could help me i would be thankful to any one who can help me out
john

lc4gs@hotmail.com
 
Looking at the manual, C23 is a tip over sensor code. Id check the connection.

4_46.jpeg
 
Mine comes on when i first turn the key on,,, I can get it to crank, and even ride it, runs fun while riding, but while riding the F I light starts flashing, When i figure it out, I will post my findings
 
Might want to also check the connector on the temp sensor; make sure it is on completely so that yyou aren't getting an intermittant reading.
 
Did the tip over switch fix your problem? I have yet to track mine down. I have replaced everything else.
 
Back
Top