Help Needed

Busa1penzance67

Registered
hi all i have just bought a power commander 2 for my gen1 busa. the problem being it needs remapping but i have no link cable well i bought a 9 pin cable to usb but it didn't seem to work i have read that you can do it manually. but i don't know where to start any help would be of great help
 
Yes. The PC II requires power to the unit. However, IIRC, remember this is a 15 year old Power Commander and I haven't seen one in at least 10 years, the 9pin serial cable that PC uses isn't a standard pin out. It had the capability to use a 9 volt battery to power the PC. But try starting the bike and see if the software sees it. You are using PC II software? AND, IIRC, you must load a base map designed for the bike into the software before it will read your PC II. It won't just read the map off of the PC II.
 
ok update got my new cable from dynojet today hohoo. iv now got base map installed it seems to be running a lot better but time will tell, thank you for all your comments
 
Back
Top