HELP: Clutch won't engage

subsailormarc

Registered
Pulled the bike out of the garage, cleaned and warmed it up, was going to go around the block, and when I put it in first the bike surged and died out like I wasn't even holding the clutch in. With the bike off I put it in first and tried to roll it with the clutch in, and again it was like i wasn't holding the lever.

I have stock levers, and this is the first time I've ever had this problem. It didn't do this last winter.

Any help or suggestions would be great. Thanks
 
Check the fluid in the clutch master cylinder...sounds like you need to bleed and top off the system.
Posted via Mobile Device
 
Well it took me longer to pull the cowling off than it did to bleed the air, but you were right, huge air bubble on the first time. Seems to be working fine now. Now comes the task of putting all the cowling back on. Thanks for the help
 
Well it took me longer to pull the cowling off than it did to bleed the air, but you were right, huge air bubble on the first time. Seems to be working fine now. Now comes the task of putting all the cowling back on. Thanks for the help

You're welcome...ride safe, wear your gear!
Posted via Mobile Device
 
Back
Top