Ban-One
Registered
OK I am in the middle of converting a Lexus HID system for use in place of my high beam. I am going to use the bikes stock high beam projector. I have cut the back of the Lexus projector so that it will fit over the Busa's projector minus the plastic bulb holder. My question is should I use JB Weld or some Perma Poxy? The PP will bond metal, glass, and hard plastic. It is good to 180 degree F . I dont remember if the JB will hold plastic. I dont know what the projector itself is made of.
Also those who have done HID, where did you mount the ballast?
Also those who have done HID, where did you mount the ballast?