GPS sensor C31, but different

Guardcasey

Registered
Hey I’m new here, I’ve had an 06 Busa motor for a few years in a custom car. Recently it’s been running really shitty, sputtering and losing power.
Checked the code, it says C31, tested resistance (good), and voltage (no good). But! I noticed the pink wire coming from the ecu was intentionally wired into the black wire and then a resistor placed between the black wire and where the pink is supposed to go into the back of the clip.
Is there a reason for this? (BTW I do not have a kickstand if that matters). I haven’t put the new GPS in yet. Will be done here in the next couple days. Thanks for any insight!

D2C2857C-7C90-4A1D-BDFE-467A5B63C4AF.jpeg


47D23F0C-97DB-4067-BE8D-3AA84CFCAD20.jpeg
 
Back
Top