Going clutch crazy ( plz help)

[snowman_45]

I just replaced the clutch in my 06 busa and for some reason I cant get it figured out. Somehow with the clutch lever pulled in when I put it in gear the bike starts to pull. I have taken everything back apart and inspected all the parts, everything looks good. The bike has been sitting for awhile so Im not sure if thats an issue. I've also bleed the system a few times but it hasnt helped. If anyone has any ideas or recommendations I am all ears. Thanks fellas.

 

[mestona]

Sounds like your stack height is too tall. That would cause the clutch to fail to completely disengage when the lever is pulled in. If I recall properly there is also a plate that can be reversed in the gen 1 which will cause that but the stack height is most likely. Take the clutch pack out and measure it against the spec (about 2 inches if I recall).

 

[dadofthree]

Best of luck