GiPro -ATRE problems





BusaCruise

speachless
Donating Member
Registered
#1
has anyone else pay close attention to their GiPro and seen that whay I do?
Mine simply cycles through all of the "brightness" settings ....and it does it 98.3% of the time.....constantly repeating from one extreme to the other.

All I did was pull it out of the box and wire it up...I made no adjustments to it...but I do not recall it doing this the first week or two I had it on.........I just happen to go for a night ride and was watching it.
It doesn't miss any of the gear changes..I am just trying to figure this out.

ohh..... and it only seems to happen while going down the road.

my only other change lately was the install of my CSS Billet cover.
 
#6
Try disconnecting it and letting it reset itself. Maybe it is getting light from somewhere else? I don't know where it is mounted? Does it do it in the day as well as at night? Maybe the photocell sensor is picking up light from somewhere?? Just a thought?
 

BusaCruise

speachless
Donating Member
Registered
#7
I do have the blue gauges installed....and they are friggin bright. perhaps I need to tape off the sensor?

but most everyone did as me right.....just hooked it up and ran.....no "set-up" required?
 

Similar threads




Top