I was thinking about changing over to a gen2 intake cam on my gen1 because it's maximum lift is 9.0mm and the gen1 has a 8.8mm maximum lift. My question is would it be worth the change or am I not going to gain much??? I was thinking this would give it a little more torque
It will shift the power band higher. The increased lift equates to lower flow velocity at low RPM's which will cause a reduction in torque down low. This will also result in more air volume at higher RPM's for an increase in top end horsepower. I wouldn't waste my time esp. over .2mm of lift. Look into the intake/exhaust cam swap or a set of aftermarket cams.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.