gen 2 turn signal removal with pics

[Joshscott07]

once the bolts/trim pieces shown are removed you may then pick up the small black plastic piece of the fairing enough see/remove the upper screw in the turn signal, then you can proceed to remove the bottom screw on the turn signal from under the front, yes the signal has two screws holding it in the dealer said it only had one lol, maybe a 10 minute job. they said it would take 1.5 hours to replace??? this is for the right side turn signal the left is the same process, i looked around for this info and could not find it, so hopefully this will help/save someone some time/money, thanks for viewing.

 

[Matte_Black]

Nicely done

 

[pashnit]

Good pics, the lil plastic ones on the inner fairing and underneath are really buggers to get out. Not sure if I need a different tool for those. I eased them out with a small flat blade screwdriver.

 

[jphilipson]

Good pics, the lil plastic ones on the inner fairing and underneath are really buggers to get out. Not sure if I need a different tool for those. I eased them out with a small flat blade screwdriver.

I just push in the middle posts on the pins, and they come right out. Sometimes just shaking the panel they are holding a bit will help them work out if needed. And I always have 5 or 6 extras in my kit, so I don't worry about losing or breaking them

 

[peterbusa]

Thankyou

 

[sportcustoms71]

 

[dadofthree]

Better than pulling the nose

 

[Joshscott07]

all i could find on the net was sayin to pull the nose or gauges so this is sooo much easier to do and alot faster. thanks for reading, but im regretting not going with the smoke signals