Gen 2 Center Stand Build For Touring .

c10

Registered
Well really a center JACK . ITs for a newer F150 truck . Modified with ZRX1200 rear axle cut down , and bolted to the factory exhaust rear hanger . I then used a old rear wheel spacer the axle fit to weld to the jack's upper plate . Now I plan on adding additional width to the jacks base ( about 2 " each side but it is pretty good now . Enough so to walk away for pictures , and spin the wheel . Can also piviot backwards to raise front wheel if needed .
I sure wish I had a factory stand like the gen 1 guys .

20170703_185848_zps8f2grnm3.jpg

20170703_192955_HDR_zpswu2rjirb.jpg

20170703_192743_HDR_zpszo1ndghc.jpg

20170703_192751_zpsmg4kl11h.jpg

20170703_192935_HDR_zps2cuaskyn.jpg

20170703_194154_zpszxyfgtvw.jpg

20170703_192719_HDR_zpsyfltiya7.jpg

20170703_192730_HDR_zpsw5sbqbs1.jpg

20170703_192710_HDR_zps0hwwnzlm.jpg
 
Back
Top