Gen 1 Busa ecu editor

[Exobusa01]

Hi all new to this forum so not sure if I’m posting in the correct place.
I’ve got a gen 1 early bike, rcc stage 1 turbo.
It was originally 16bit but I done the conversion to 32 bit with an 02 ecu.
I went to install the Boost by Smith interface but as I’m still using the 16 bit loom some of the terminals all ready have wires in them,
Has anyone got round this?
Many thanks

 

[08BusaKY]

Welcome! I'm sure someone can answer your question. I have never owned a GEN1 sooo….

 

[ogre]

Someone around here knows, we just have to irritate the oldies until they decide to answer.

 

[Mr Brown]

Shoot Greg an email, I'm sure there's a way around it. I swapped my 00 over, but I did it under strict instruction and I've slept since then...
GREG@BOOSTBYSMITH.COM

 

[sixpack577]

There is/was a repin diagram here for the conversion to 02+.
Ecu Editor only uses 2 pins into the ecu, and 2 at the Yosh plug to connect it.
You may to need to reference the wiring diagrams in the service manuals too, so you know what locations to move things to.
Sorry I don't know which ones directly.