David Offor
Registered
That’s a great post, very useful for future use, nice mod on the holding tool
.
Fork seal and oil change.
- Thread starter David Offor
- Start date
.
David Offor
Registered
Outside the blue pub, they do great wedges in there, also they cordon of the road and do a street race too, it always has something interesting going on. Don smith is next to the show ground, near Brinkley lodge, heading out to rakia gorge, I haven’t been in contact for a year tho.
Nice pair of bikes, classic paint job on the busa.
David Offor
Registered
I usually travelled the ashburton route, to go to Christchurch but have been through darfield, is it bigger or smaller than methven?
David Offor
Registered
Sometimes nature provides the ‘special tools’ 
.
Straightening the headstock on one of my748 s, that i crashed getting my knee down on a roundabout, one week later repaired and riding around Spain for 2 weeks, good ole steel trellis frames on the Ducati’s.
.Straightening the headstock on one of my748 s, that i crashed getting my knee down on a roundabout, one week later repaired and riding around Spain for 2 weeks, good ole steel trellis frames on the Ducati’s.
Nastee
Registered
Well it turns out the dampener cartridge is actually made of 3 outer parts not 2 as it seemed. Either side can unscrew; which will loosen depends on which was tightened down the hardest at factory. Bottom unscrewed on one fork & had to use a pipe wrench on the tube which was the perfect tool no damage. These were all the parts inside cartridges.
#Braaap@Life
Registered
You interested in selling a tool
Similar threads
