Front wheels will need:
1.5mm spacer rotor off of wheel,
additional 3mm of spacer on each side of axle,
5mm spacer for calipers to go from 310mm to 320mm rotors.
Rear needs:
Sprocket will need to be spaced out to align chain(mine are Marchesini's so I'm not sure on stockers)
Caliper needs to be converted to Gen 1 underslung caliper set-up, or
Have new rotor made as Gen 2 rear rotor is 260mm and Gen 1 is 240mm
Not really hard to do at all, but it just takes a little using some common sense.