ECU Electrical connector

LiBusa

Registered
When I removed the ECU I broke the plastic lock tab on one of the electrical connectors.  Any suggestions on how to repair or make sure that electrical connections stay attached to each other.

~Lionel

DSC02247.JPG
 
Plug it back in then take a long black zip tie and push it right through the middle of the wires coming out of rear of plug, wrap it around ECM and secure it. Done!
 
(05BusaLe @ Feb. 02 2007,19:04) Plug it back in then take a long black zip tie and push it right through the middle of the wires coming out of rear of plug, wrap it around ECM and secure it. Done!
bowdown.gif
 
If you can't find a very small wire tie, then crisscross two from the outside. The connector might actually be tight and not require any additional restraint. Anyone know if the pins pop out ? If they do you might be able to get the connector cheap from an electronics store, pop the pins out and push them back into the new body. Good Luck
beerchug.gif
 
(dadofthree @ Feb. 02 2007,23:35) If you can't find a very small wire tie, then crisscross two from the outside. The connector might actually be tight and not require any additional restraint. Anyone know if the pins pop out ? If they do you might be able to get the connector cheap from an electronics store, pop the pins out and push them back into the new body. Good Luck  
beerchug.gif
The pins do come out but you will need an extractor so the pins dont get damaged, just not worth it!
 
(GoldenChild @ Feb. 02 2007,22:21)
(05BusaLe @ Feb. 02 2007,19:04) Plug it back in then take a long black zip tie and push it right through the middle of the wires coming out of rear of plug, wrap it around ECM and secure it. Done!
bowdown.gif
sm65.gif
 
Back
Top