Arctikdiver
Registered
Greetings from Finland.
I was planing istall intake shaft to exthouse side...
Have anyone done this, if so settings for cams..?
How about exhouse pressure..?
Turbo set at my ride is Mc Express stage2, charger is McX400.
Last season I used 0,85bar, that gave RWP 251 and 237Nm torque.
Target is gain 30-40hp from rear wheel.
Block is raised 2mm, stronger bolt sets up and down.
Stock pistons with Carillo H-beam rods.
Thanks for Your input!
-jari-
ps Sorry my spelling :-/
I was planing istall intake shaft to exthouse side...
Have anyone done this, if so settings for cams..?
How about exhouse pressure..?
Turbo set at my ride is Mc Express stage2, charger is McX400.
Last season I used 0,85bar, that gave RWP 251 and 237Nm torque.
Target is gain 30-40hp from rear wheel.
Block is raised 2mm, stronger bolt sets up and down.
Stock pistons with Carillo H-beam rods.
Thanks for Your input!
-jari-
ps Sorry my spelling :-/