Dogbones

[Efreo]

For what it's worth, I'm trying to attach a CAD file of my dogbones. I think they are an improvement on what is generally available, as no mods required and std, -50mm and -100mm easy to change by undoing just the lower bolt. No mods to frame and the lower fairing stays in place. Possible to play around with the 50mm and 100mm numbers a bit. Even possible to go higher as well if required, all without mods to the bike.

 

[nitrousjunkie]

Just save the pic to your computer and use the upload feature on posting.

 

[Efreo]

The file I've attached is a CAD file. I haven't tried posting a picture on this yet, but I have one on Phoobucket of the prototype. I'll wait till the new ones are cut and polished up, and then I'll post a picture of them.
Thanks