Do all the handlebar controls unbolt?

[BowDown]

If I was to replace the handlebar shafts... will all the stock control pieces come off by unscrewing/unbolting? Or are some things like the grips glued to the shaft?

Thinking about getting clip-ons and I'm not sure if I can reuse the stock bar shafts... so I may have to transplant the handlebar items to the new shafts.

Thanks!

 

[HillbillyTom]

Left grip is going to be glued on, but everything else is bolted on.
I just changed grips on my bike and the stock left grip peeled off fairly easy, throttle grip can come off with the throttle tube in your case. Hope this helps..  Tom

 

[BowDown]

Sure does. Little compressed air or water seems to help the left grip come off?

 

[HillbillyTom]

Slide a screwdriver under the grip and work it around the bar end to loosen the glue then I shoot a little WD-40 up under the grip and off it slides.
Clean the WD out of the inside of the grip and reglue it on the new bar end.

 

[mjrfd99]

Changed my stock bars to Heli bars was easy - controls came off easy the bar end weights were on like they were welded- Had to heat up w/torch and use an impact tool to remove