Clutch apart help

[03busaman]

Just pulled the clutch out to do the mod and looks like this pic one the how the stack came out with the ring just floating in there
2nd photo 1 ring sitting on there
3rd photo ring made slight groove in plate
4th plate blue heat burn every metal plate in the stack is like that
Suggestions anyone seen this before

 

[03busaman]

the stack still measures over 50 mm

 

[mike1180]

I don't know about the markings, but if it were mine, I would ride it, if it wasn't showing any problems before.
If you have to replace them I would do them all at once, including the metals.
There are lots of reasonable aftermarket ones out there (I have a spare Barnett myself)

 

[Commuta_Busa]

If the thickness is still in spec you're ok (measure each steel & fiber). Only has a little overheat spots. The ring can grove the steel but only by a little bit. If it's really cut into the plate I would swap in a steel. I've seen worse.

 

[03busaman]

Yea i ordered an oem set of steels and fibers when i failed the 3.08mm and 3.88mm min measurement on the individual fibers.
But first time taking this unit apart for me the rings just sit in there like that ?

 

[BATTMAN]

Has the clutch ever been apart before. Make sure you put the steels back in there the right way.

 

[03busaman]

Has the clutch ever been apart before. Make sure you put the steels back in there the right way.

no it hasnt the question i got is those skinny rings just sit in the back of the pack

 

[03busaman]

Has the clutch ever been apart before. Make sure you put the steels back in there the right way.

Are you saying its not ok to leave it empty till the new parts get here?

 

[BATTMAN]

its ok to leave them out until the parts get there. some people dont even use that extra ring at all.