So guys I have a 01 busa gen 1 that having some difficulties with code is coming up for cam shaft sensor replaced that and fi still flashing coming up same code c11 for camshaft sensor any advice as to why do I just need codes cleared for that to fix it also start not engaging properly was curious if the that sensor will cause that bc starter and starter clutch and starter relay are all new
Busa won't start
- Thread starter erob_15
- Start date
Clearing the code will not fix it.
Sorry, that should have said the code will clear when it is fixed.
And no, I'm not sure, or familiar with the 2001.
1999 and 2000 are the same.
02-07 are the same.
The 2001 has a few differences, including the ecu.
I would have to go through the service manual to troubleshoot it.
@Berlin Germany
Any ideas?
And no, I'm not sure, or familiar with the 2001.
1999 and 2000 are the same.
02-07 are the same.
The 2001 has a few differences, including the ecu.
I would have to go through the service manual to troubleshoot it.
@Berlin Germany
Any ideas?
So update I don't have any power going to the cam sensor wire itself tested with multimeter checked harness and so far I've taped up some wires that were touching but still didnt fix
Similar threads
