Busa gauge

djac2163

Registered
Can any one comment on how to install the busa custom gauges.Is it hard or can i do it my self?

GSX1300RK6_BlackRed_640009.jpg
 
remove the cluster, remove the obvious bolts on the back and gently pull the two halves apart. when you remove indictor needles, it will take some gentle prying with something more than your fingers. just as you are about to pull each needle, place a small mark on the side of the pin that is on the same side as the "stop". that way you know where to align the needle on the pin.
 
Top