Brocks System

F

fightermc

Registered
ok lads I have read a few post on this
and lads have had success with the answers
but mine is leaking at the head where the flanges sit.
I have done everything to try and solve this
but still leaking....new gasket fitted too.
have had it on and off more than 10 times...
pissing me off now,is it ok to use high temp silicone in around it
and if so what one you recommend.
thanks
 
Is it leaking around your exhaust gasket or where the header pipe goes on the flange? If it's where the pipe goes on the flange Brocks actually sends copper high temp silicone for that joint. So I guess it's ok to put some there.
 
piratediverjefff said:
Something's definitely out of whack bro,I installed my Short Meg reusing original gaskets and no Permatex(Ultra Copper which came with the exhaust)with no leaks after 11,000 miles(make sure you have the right side of the flanges against the gaskets).

http://www.brocksperformance.com/Instructions/Hayabusa/992274.pdf
Click to expand...
I had it off again today and put hi
piratediverjefff said:
Something's definitely out of whack bro,I installed my Short Meg reusing original gaskets and no Permatex(Ultra Copper which came with the exhaust)with no leaks after 11,000 miles(make sure you have the right side of the flanges against the gaskets).

http://www.brocksperformance.com/Instructions/Hayabusa/992274.pdf
Click to expand...

had it off again today and put high temp copper silicone sealment in around it so will check/start it again tomorrow to see if this sorts it.....thanks for the replys
 
You must log in or register to reply here.

Similar threads

Furball
Full system and PAIR blockoffs installed...problem
Replies
6
Views
949
foresteronw
F
I
Exhaust leaks
Replies
5
Views
827
Somebody1010
S
H
brocks exhaust leaking
Replies
2
Views
884
hemi
H
H
brocks exhaust, supposed to use header gaskets, correct?
Replies
3
Views
3,895
SLEEPERBUSA
SLEEPERBUSA
k9ill5a
Oil Leak
Replies
7
Views
1,263
Schism
Schism
Back
Top