Bike killed, pc5 has no power, tach acting up

[Quiksilver]

So I just finished a ton of wiring a few days ago. I come back from vaca and finally got the neutrino working and configured. I have the wideband and auto tune installed on neutrino. I went for a ride last night and all was perfect. I'm riding today pull in. Clutch and the bike immediately dies. The light does not come on the pc5, only when plugged in. I had to plug the pc5 into my tablet to get home. The tach is also acting strange.

 

[jeffgordons24]

I would check the connection to the PC, see if your getting 12V to it. If I am not mistaken the PC takes it power from the FI fuse and only sees power on initial key on and when the bike is running.
Maybe it’s as simple as a loose power wire or blown fuse.

 

[Quiksilver]

I would check the connection to the PC, see if your getting 12V to it. If I am not mistaken the PC takes it power from the FI fuse and only sees power on initial key on and when the bike is running.
Maybe it’s as simple as a loose power wire or blown fuse.

I plugged in the pc3 and it powers on. I checked the fuses under panels and I dont see any blown failures. Oddly enough the fan stays on now....

 

[john blaze]

I had almost the same problem about 2 months ago...... replaced my rectifier...... last thing I would have checked...... but now she runnin right as rain.

 

[jeffgordons24]

I plugged in the pc3 and it powers on. I checked the fuses under panels and I dont see any blown failures. Oddly enough the fan stays on now....

Sounds like maybe the pc5 took a dump.
I know @POWERHOUSE just experienced this recently with @faseljd Bking.

 

[Quiksilver]

I believe so, I got with fuel moto and. Is need to get in touch with dynojet. I have the worst luck with this bike.