Hey all just finished the ZFI install took about 6 hours doing it at a relaxed pace.
I wanted to post a few pics of the differences I encountered on the way.
Firstly the crank position sensor was so far inside the left fairing that had to be removed
Secondly the O2 sensor plug is Blue and routed on the right side of the bike not the left as in the install instructions so I had to remove that fairing as well.
Finally the power wire to use for the Bazzaz power connector is Orange with a Green Stripe.
Hope this helps a bit.
I wanted to post a few pics of the differences I encountered on the way.
Firstly the crank position sensor was so far inside the left fairing that had to be removed
Secondly the O2 sensor plug is Blue and routed on the right side of the bike not the left as in the install instructions so I had to remove that fairing as well.
Finally the power wire to use for the Bazzaz power connector is Orange with a Green Stripe.
Hope this helps a bit.
to the oRg 
