Hello,
I've been recently installing my Bazzaz TC system in my gen 2 prior to flashing the ECU to narrow the band of correction for fueling and have run into a wiring problem, they're everywhere which is obviously why it would have been better to just flash the ECU and skip TC.
In regards to this I was wondering if anyone has any pics or insight into how to properly set the unit direction and place the wires coming directly from the unit? I've got it fairly well sorted out in a mess beneath the gas tank, but up top, it just doesn't look like anything is going to be fitting back together for my tail section. Secondly, does anyone who runs the TC and map switches have any pics or insight into that setup such as a specific handle bar clamp to use? I've tried to fit some plumbing bar clamps to get the general outlook, and I'm definately going to need a specific size to work it in.
Thank you from the Villiage idiot,
Jon
I've been recently installing my Bazzaz TC system in my gen 2 prior to flashing the ECU to narrow the band of correction for fueling and have run into a wiring problem, they're everywhere which is obviously why it would have been better to just flash the ECU and skip TC.
In regards to this I was wondering if anyone has any pics or insight into how to properly set the unit direction and place the wires coming directly from the unit? I've got it fairly well sorted out in a mess beneath the gas tank, but up top, it just doesn't look like anything is going to be fitting back together for my tail section. Secondly, does anyone who runs the TC and map switches have any pics or insight into that setup such as a specific handle bar clamp to use? I've tried to fit some plumbing bar clamps to get the general outlook, and I'm definately going to need a specific size to work it in.Thank you from the Villiage idiot,
Jon
