Not sure if this is the right place to ask this but just wondering if anyone has tried adding 1.25" risers to the fork clamp? The tallest i've found are 1" but i think ideally 1.25" would be preferred. Haven't been able to find any info on risers over 1" so maybe it's not advisable.
Bar Risers???
- Thread starter Buceoman
- Start date
The reaper risers were 1 1/4 or 1 1/2. You can make your own at any hardware.
02BusaMark
Registered
After you get to a certain height, you may start to hit your upper cowl when turning the handle bars. Think I have 1.25" and the resevoirs barely clear.
AND you'll definitely need longer brake lines....
Brake and throttle lines etc, weren't an issue but I did come close to dumping the bike when the brake lever hit locking left. Good point.
I had 1.5" risers on my gen2 with no issues.
The stock brake/clutch lines were long enough also.
I later switched to heli-bars and cut the risers down to .75"
The 2 combined still cleared the inner windshield and the stock lines had enough slack.
The stock brake/clutch lines were long enough also.
I later switched to heli-bars and cut the risers down to .75"
The 2 combined still cleared the inner windshield and the stock lines had enough slack.
911JSS
Registered
Can you pls share photo of your setup, if you still have that
sixpack577 hasn't been active since May of this year...I wouldn't expect any photos...
Similar threads
