dabeechman
Registered
Anybody ever experience this? I have their 10mm studs, and recently rebuilt the motor after a JE piston came apart. I called APE to ask if this is normal and they blamed my torque wrench by saying it is out of calibration.
I find it interesting that half of them torqued fine, and the rest wouldn't hold a torque. The ones that wouldn't hold a torque measured at .070"+ longer than when I started.
So my question I guess is, have you seen this before? Normal?
Should I be pissed that their only suggestion was to sell me another set @retail?
I find it interesting that half of them torqued fine, and the rest wouldn't hold a torque. The ones that wouldn't hold a torque measured at .070"+ longer than when I started.
So my question I guess is, have you seen this before? Normal?
Should I be pissed that their only suggestion was to sell me another set @retail?