APE Heavy Duty Clutch question

[bulldoggie]

Hello All,

does anyone know if the Ape Heavy Duty clutch drive plates and driven plates are supposed to be gaged in thickness and put in the order of factory plates, by that I mean specifically #1 and #2 driven plates in the Busa manual on pg. 560. plate #1=.080 and #2=.090, all my Ape plates were the same thickness (give or take .0005). Any help appreciated!

Bulldoggie

 

[dadofthree]

I don't know my arse from a hole in the ground on this one, but if they're all within that close a tolerance, I wouldn't think it would matter. I would contact APE. Good luck