Anyone running a horizontal air shifter setup?

Nice.....I LIKE that! :thumbsup: ....black chrome... :drool:

That's a very nice setup and looks clean.....looks like I've found another project... :laugh:
 
One thing I learned: The screws that attach the aluminum block to the shift shaft are too long. Get a nut and thread it on, then cut about three threads off so they don't scratch your frame.
 
One thing I learned: The screws that attach the aluminum block to the shift shaft are too long. Get a nut and thread it on, then cut about three threads off so they don't scratch your frame.

Good tip! My only question now is will it work on my aftermarket shift rod. The Gilles rearsets use a larger diameter than OEM and it doesn't look like much room in your pics... :(
 
I am sure that any competent machinist could probably make one up that is thinner on the back and has a larger hole for the Gilles rod
 
Ludicrous, I didn't see it mentioned but what bracket are you running on the gen 2? I am looking for something like that.
 
Back
Top