Another MSD 4350 idiot.. Lend me a hand!

tnarmyng

Registered
So I got my Gen 1 with a PCV installed. Added a Launch Master and I've got no fuel pump prime/no start.

Do you have to have the ignition control module to use the PCV and MSD launch master together? With both installed I get the active light when I test the launch master clutch ground install per instructions, but I can't start with both installed. I've had PCV installed for a while.

I figured PCV to injectors with launch master to coils would be fine set up like that. Apparently not.
 
Red LED on with ignition even when my activation (clutch, not 12V) wire isn't connected to ANYTHING.... wtf

Swapped the connectors to opposite harness plugs, confirmed good ground connection, no CELs, tried with clutch wired to the proper wires at harness, NO CHANGE!
 
Back
Top