I am building a car with a 2001 gen 2 Hayabusa engine, Ive stripped the wiring loom of all non essentials, I loaded the US Bin file I have since read & saved the Bin File with WRT changed some advanced settings (disableTOS OEM Oxy sensor, Pair) & flashed it back to the ECU with WRT, all good! I was looking at the live data while it was running & noticed the clutch display is showing clutch in, when in fact the B/Y wire is cut close to the ECU, which should be clutch out, tried earthing it but no change, its as though the wire is earthed, (clutch in) of course this means it going to run in the neutral maps all the time, anyone had this issue? or any ideas?