Do you have the tail bodywork off the bike. If so you should have had to unplug 2 connectors to get it off. The smaller 2 wire connector is for the license plate light and the larger connector is for the brake light. I have a service manual for the 08 I can take a look in that and find out exactly.
According to the book it says you can access it from underneath the tail by removing the rear fender, but I would just remove the tail section to get at it. Its pretty easy to do.
I believe its a 4 wire whit connector its located at the very rear in the "trunk"area ya mite not be able to get to it unless the tail or that fender is removed. I hope this helps ya.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.